S236 Shift Crew's Basic Procedure

(Anyone please add comments and descriptions)



Change Run Procedure


actiondescription
1run close procedure
2Stop BeamPress Red Button
3Change TargetBe sure that the ladder locates at optimized position, NOT nominal position
4Start Beam
Press Green Button
5run start procedure
6Fill out Run Sheet




Run Start Procedure

Window Numberactiondescription
-Make sure that Drift-Chamber is O.K. If some of the plane tripped, note it on the Book.
1E7_14> open file r93_XXX start writing data to DLT tape with name "r93_XXX"
2Check whether it's running.
If no, type
piatom@kcpc38% ./startrev
remote event server running on kcpc38
3Check whether it's running.
If no, type
piatom@kcpc38% ./start_analysis
remote event service client1 for online analysis
4piatom@kcpc38% ./tcpread -s localhost > save.lmd/r93_XXX.lmd remote event service client2
save raw data also on HDD



Run Close Procedure

Window Numberactiondescription
-Check none of the Drift-Chamber plane tripped.
pawPAW> hbk XXXsave online histogram to disk as r93_XXX.hbk
4kill proccess by Ctrl-Cstop writing data to HDD
3leave it
2leave it

1E7_14> close filestop writing data to DLT tape



Our Working Screens and Windows




Optimized Positions for strip targets

target
number
name nominal position x[mm] nominal position y[mm] optimized position x[mm] optimized position y[mm] data found at
14 206Pb 36.8 -304.9
20 112Sn/My 12.8 -14.6
21 70Zn/My 12.8 -38.2
22 124Sn/My 13 -61.4 12.3 Logbook3-p84
23 120Sn/My 13 -84.6
24 116Sn/My 12.8 -107.6 12.5
Logbook3-p63
25 PE 12.8 -131
26 PE 13.2 -154.3 Logbook3-p46
27 116Sn/Ac 13.2 -177.4 12.8
Logbook3-p43,Logbook3-p61
28 120Sn/Ac 13 -200.3
29 124Sn/Ac 13 -223.7 12.9
Logbook3-p45,p46
30 70Zn/Ac 12.8 -246.8
31 112Sn/Ac 13.2 -270
32 Al 12.6 -293.2
33 PE 12.6 -316.4
34 PE 13.2 -339.7
35 116Sn 13.2 -362.8 12.7
Logbook3-p59
36 120Sn 13 -386
37 124Sn 13 -409.1
38 70Zn 13 -432.4